Division: 600

600 Menu: Order form (PDF file) Parts list (Webpage) Parts list (PDF File) Installation instructions (below) Installation instructions (PDF file)

Dri-Bar Install Instructions for the 600 Division

1. Remove caps from chassis clamps (large bore) attached to torsion bar
2. “Loosen” allen bolts in round torsion bar clamps and slide towards center slightly.
3. Mark chassis clamp location on chassis (unit 1” wide).
4. Set system in place on lower frame rail in between marks ----->|C|<------ 1” wide.
   a) On sprint’s it will be 12” forward of center of rear axle to center of torsion bar     
   b) On midget’s it will be10 ¾” forward of center of rear axle tube to center of torsion bar
   c) On 600’s either 10 ¾” or 12 ¼” from centerline of rear axle (depending on the application) to center of torsion bar.
   d) PMP units will mount on 1” lower seat cross tube
5. Install lower cap with bolts slightly loose.
6. Lightly tighten teflon screw in upper cap to align clamp.
7. Tighten lower frame caps bolts “evenly” and keep gap equal in order to NOT twist clamp.
8. Remove teflon screw and install grease zerk  – grease until FULL.
9. Slide torsion bar back and forth side to side slightly to ensure bar is COMPLETELY FREE – IF NOT – repeat steps 6 - 8 until FREE            
10. Remove your torsion arm bolts and install bolts supplied.
11. Install LR drop link first by bolting to drilled and tapped torsion arm bolt supplied with Kit – then bolt to flex blade of arm.
12. Install RR drop link by first bolting it to the drilled and tapped torsion arm bolt supplied in kit–  (determine if spacer needed to align with torsion bar) then adjust to length and attach to torsion bar.
13. Now center torsion bar in order to have the drop links hang down as close to vertical as possible. Move torsion bar clamps (supplied) to within 1/8” inch of chassis clamps and lock in place. (1/8” to 3/16” total end play suggested)
14. Route cable (longer cable for right side across rear torsion tubes, over Jacobs ladder, and to right side of cockpit.
15. Install cockpit control unit – set with handle towards rear of car – install cable mount – pull mount and cable to end of adjustment away from control – move back 1/8” – tighten clamp bolts.
16. Ty-wrap cable “SECURELY”.
17. ***Adjust length of RR drop link until lower bolt slides into torsion bar W/ NO load on bar, with driver seated in car, chassis blocked, tire pressures set, race car ready for competition
18. Soften RR torsion by .025 from standard set-Up
19. Follow recommended shock suggestions.
20. Moving handle down or towards rear will loosen car and up or forward will tighten car